Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
   Security measures at work
   + Suspension bracket of forward wheels
   + Suspension bracket of back wheels
   + Corners of installation of wheels of the car
   - Steering and safety pillows
      The general data and security measures
      Removal and installation of the block of a pillow of safety
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment



Removal and installation of a tip of steering draught

Removal

 PERFORMANCE ORDER

  1. Mark on the tyre a direction of its rotation. Turn away bolts of fastening of a wheel. Lift and establish on supports a forward part of the car and remove a wheel.
  1. Turn out a bolt (1).
  1. Turn away a nut (5) and turn out a bolt (2).

Do not expand шлиц in the case of the bearing of a wheel with a chisel or any other similar tool.

Do not apply a chisel or any similar tool to removal of steering draught by забивания it between the pendular lever (1) and a sealing washer (2) tips of steering draught. Steering draught can act in film only by выпрессовки the end of a pin of a tip from the steering lever or blows of a wooden or rubber hammer.

  1. Remove steering draught downwards.
  1. Turn away a counternut (3) and turn out a tip from steering draught.
  1. Wipe a tip of steering draught and клеммное an aperture on the case of the bearing of a wheel.

Installation

 PERFORMANCE ORDER

  1. Screw a tip on steering draught against the stop.
  2. Tighten a counternut (3) moment 40Нм. HUNDRED AUDI apply for this purpose tool V.A.G 1332/12. At an inhaling keep steering draught from проворачивания for шестигранник (4).
  3. Expose steering draught so that the tip pin was in installation position.
  1. Insert steering draught against the stop into the pendular lever.

Steering draught insert into the pendular lever (1) only by hand, thus do not press strongly on a sealing washer (2) tips.

  1. Insert a bolt (2) and screw a new nut (5), tighten a nut the moment 50Нм.
  1. Establish a bolt (1) and tighten its moment 7Нм.
  1. Establish and fix a wheel, observing a direction of its rotation. Lower the car and only after that tighten bolts cross-wise the moment 120Нм.
  2. Spend measurements of a running gear of the car (work HUNDRED).