Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   The general data and security measures at carrying out кузовных works
   Cleaning and leaving
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   - The external equipment
      Installation of the forward panel in position for maintenance service
      Removal and installation of a cover of a water modular compartment
      Removal and installation of a forward bumper
      Removal and installation локера a back wing
      Removal and installation локера a forward wing
      Removal and installation of a forward wing
      Removal and installation of a back bumper
      Removal and cowl installation/adjustment
      Removal and installation of a cable of a drive of a cowl
      Removal and installation of a clamp of the lock
      Removal and installation of facing of a forward door
      Removal and installation of facing of a back door
      Removal and door installation
      Door adjustment
      Removal and installation of a frame of a window of a forward door
      Removal and installation стеклоподъёмника
      Removal and installation of the electric motor of a drive стеклоподъёмника
      Removal and installation of the lock of a door
      Removal and installation of the handle of a door
      Removal and installation of the cylinder of the lock of a door
      Removal and installation of facing of a cover of a luggage carrier
      Removal, installation and adjustment of a cover of a luggage carrier
      Removal and installation of the lock of a luggage carrier
      Removal and installation of facing of a door of a back (Versatile person)
      Removal and installation of a door of a back (Versatile person)
      Removal and installation of the lock of a door of a back (Versatile person)
      Removal and installation of an external mirror
      Removal and installation молдингов
      Removal, installation and check сдвижной roof panels
      Removal and overlay installation сдвижной roof panels
      Check and starting position adjustment сдвижной roof panels
      Removal and sealant installation сдвижной panels
      Replacement of elastic bands of brushes of a screen wiper
      Removal and jet installation стеклоомывателя a windscreen
      Removal and installation of a jet of a washer of back glass
      Removal and installation of the lever of a cleaner of a windscreen
      Removal and installation of the lever of a cleaner of back glass
      Removal and installation of jets фароомывателя
      Adjustment of levers of a screen wiper
   + The salon equipment
+ Onboard electric equipment



Removal and installation of a forward bumper

Forward bumper

1 — Two bolts, 23Нм
2 — the Air lattice
3 — the Screw
4 — Planck. It is fixed by means of a bilateral sticky tape. Therefore at removal collapses
5 — the Bumper
6 — Directing

7 — Six clips
8 — Two plugs
9 — bumper Shock-absorbers
10 — the Wing
11 — the Special nut
12 — Loker
13 — Two screws

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

Operation of lifting and car installation on supports is connected with danger! Therefore before operation carrying out familiarise with Section Removal and installation of plafonds of internal illumination.

  1. Mark on tyres with arrows a direction of their rotation. Loosen the bolts of fastening of a wheel. Lift and establish on supports a forward part of the car and remove wheels.
  2. Remove in front the bottom cover of the engine, address to Section Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher.

Some kinds of works are carried out as with left and справой the parties. However they are described for one of the car parties.

  1. Turn out bolts from below and disconnect локер in a forward part from a bumper, and also from a cross-beam.
  1. Wring out локер (marksman) and turn away a bolt (2) and nuts (1).
  1. Remove a lateral part of a bumper (marksman).
  1. Take away a screw-driver lock laths with (1) on (4) (an arrow on an accompanying illustration), disconnect a lattice and take out from a bumper.
  1. Turn out a bolt (1) which are behind, address to an illustration the Forward bumper.
  2. Pull a bumper forward.
  3. Remove a hose фароомывателя if it is available.

Substitute capacity for gathering of following water.

  1. Disunite all sockets going to a bumper.
  2. By means of the assistant remove a bumper forward from shock-absorbers of collision (9).

Installation

 PERFORMANCE ORDER

  1. Check up, whether carving pins on each side a bumper, and also clips (7) and plugs (8) in wings are established, address to an illustration the Forward bumper.
  2. Installation is carried out in sequence, return to removal. Thus fix a bumper to shock-absorbers of collision by the moment 23Нм. Watch that carving pins from bumper sides have entered into apertures on a wing.
  3. Fix wheels, observing a direction of their rotation. Lower the car on wheels and only after that tighten cross-wise bolts of fastening of a wheel the moment 120Нм.
  4. Attach a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.