Audi A4, S4

Since 2000 of release

Repair and car operation



Audi A4, S4
+ Introduction
+ Controls and receptions of safe operation
+ Current leaving and service
+ The engine
+ Systems of cooling, heating and the air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of an electric equipment of the engine
+ Manual box of a gear change
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   The general data and security measures at carrying out кузовных works
   Cleaning and leaving
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   + The external equipment
   - The salon equipment
      Remarks on work with the salon and security measure equipment
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of a lay brake
      Removal and installation of a cover of the lever of switching of transfers/selectors
      Removal and ashtray installation
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and cover installation on a control panel
      Removal and pocket installation from outside the driver
      Removal and installation of a ware box
      Removal and installation противосолнечного a peak
      Removal and installation of facing of a rack And
      Removal and installation of the top facing of a rack In
      Removal and installation of the bottom facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Versatile person)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment








Removal and installation of facings (Sedan)

Rack With

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures.

  1. To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
  2. Remove closing lath of a roof, see more low.
  1. Turn out screws (2).
  1. Remove lateral pillows of a back seat, address to Section Removal and installation of a back seat.
  2. Take out a clip (3) under a lateral pillow.
  3. Disconnect a lateral shelf and raise it, address to corresponding Section.
  4. Disconnect facing of a rack With (1) at a spring clip (4) and remove it.

Installation

 PERFORMANCE ORDER

  1. Raise a shelf and insert facing of a rack With into grooves on a regiment.
  2. The further installation is carried out in sequence, return to removal. Thus replace self-stopped screws (2) with the new.

During joining of the storage battery in salon there should not be people.

  1. Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery accumulator room.

Observe instructions Replacement of the storage battery Has undressed.

Rack D

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures.

  1. To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
  2. Remove facing of rack D, address to corresponding Section.
  1. Press downwards the handle (5) and cast away downwards a cover of the screw (4). For this purpose enter into a groove (7) thin wire and open a cover.
  1. Turn out screws (6).
  2. Turn out the screw (3) and disconnect behind facing of a rack And, address to corresponding Section.
  3. Extend facing (1) under facing of a rack of Century
  4. Disconnect facing of rack D (1) at spring clips (2) and extend from a shelf.

Installation

 PERFORMANCE ORDER

  1. Enter into a shelf facing behind rack D.
  2. Insert a hook (7) in шлиц at facing of a rack With.
  3. Fix facing of rack D at spring clips (2).
  4. Insert forward facing under facing of a rack of Century
  5. Check up, that the clip and a hook of the adapter of a pillow of safety have been reliably fixed.
  6. Screw the screw (3) and fix facing behind a rack And.
  7. Fix the handle new self-stopped screws (6). Put into place a screw cover.
  8. Put over facing a door sealant.
  9. Establish into place a lath of the lock of a roof, see more low.

During joining of the storage battery in salon there should not be people.

  1. Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (+), and then a negative cable (-) to a battery accumulator room.

Observe instructions Replacement of the storage battery Has undressed.

Closing lath of a roof

Removal

 PERFORMANCE ORDER

  1. Disconnect closing lath of a roof (1) at spring clips (2) of grooves (3) and remove.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal.

Back entrance lath

Removal

 PERFORMANCE ORDER

  1. Remove the bottom facing of a rack In, address to Section Removal and installation of the bottom facing of a rack of Century
  2. Remove facing of a rack With.
  3. Remove a lateral pillow of a back seat, address to Section Removal and installation of a back seat.
  4. Disconnect an entrance lath at three spring clips and remove.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal.

Shelf

Removal

 PERFORMANCE ORDER

  1. Depending on the equipment: Cast away a back of a back seat or remove, address to Section Removal and installation of a back seat.
  2. Disconnect from a shelf facing of a rack With at the left and on the right.
  3. Remove the left and right lateral pillows of a back seat, address to Section Removal and installation of a back seat.
  4. Not leaning back back seat: Disconnect below the central seat belt.
  1. Remove from a shelf by means of a plastic wedge a lattice of a loudspeaker (3).
  1. Depending on the equipment turn out 3 or 4 screws (4).
  2. Turn out from below 3 screws of fastening solar шторок in a luggage carrier and extend a curtain forward.
  3. Pull a shelf (1) forward (marksman), disconnect at an edge (2) and take out upward.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal.

Lateral facing of a luggage carrier

Removal

 PERFORMANCE ORDER

  1. Open a luggage carrier and take out a floor cover.
  2. Remove facing of overlapping of a back.
  3. Remove a back of a back seat, address to Section Removal and installation of a back seat.
  4. Turn out bolts of fastening of eyes of a luggage carrier.
  5. Disconnect lateral facing at four spring clips above and behind and remove upwards. If it is necessary, preliminary open in facing a cover боковины.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal. Thus a door sealant put over facing.

Back overlapping

Removal

 PERFORMANCE ORDER

  1. Open a luggage carrier and take out a floor cover.
  1. Turn away 2 nuts (2), if necessary, take out a spare wheel.
  1. Disunite a socket of a lamp of illumination of a luggage carrier.
  2. Disconnect facing of overlapping of a back (1) in four spring clips (3) and remove overlapping.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, return to removal.